The Portal *Blem*


This is a blem item. Anodizing is 100%, however the laser engraving does not meet the QC standards.

Introducing the Portal by Ghostmen Designs. Designed to let dirt, brass, gravel , etc to fall out through the bottom of your holster, to ensure that you are able to re-holster your weapon.

After seeing many agencies remove the light plug to allow debris to fall through, Ghostmen Designs realized that doing such resulted in zero protection for the weapon light, and weakened the structural integrity of the holster.

Machined from T6 6061 Aluminum Mil Spec anodized
Made in the USA

*See installation instructions below. Only works in Safariland 6000 Series light bearing holsters.

*Safariland is a Registered Trade mark of Safariland, LLC



  1. Remove holster from mount
  2. Loosen the screw (1/8″ allen key) on the base of the holster
  3. Remove the factory plastic plug
  4. Press the Portal in its place, making sure it is fully seated all around into the channel
  5. Tighten the screw back up and re-mount the holster

Holster strength retained, light protected, and debris can fall out the holster.


Additional information


Black, FDE, ODG

You may also like…